PR-2 Troubleshooting Guide
Table of Contents
Note: It is strongly recommended that only qualified technicians use these repair guidelines, ignoring to do so could result in a void of your warranty. This information is to be used as a guideline only, and cannot be guaranteed to solve your specific repair issue.
No Weld or Poor Weld
- Welder power not turned ON. (Turn it on.)
- Dirty gun tip or bad setup. (Replace tip. Clean tip or work piece.)
- Failed trig switch inside gun. (Check continuity and replace if open loop.)
- Broken trig wire betw gun & circuit board (twin-lead comm. cable). (Check continuity and replace if open loop.)
- Tripped or bad/broken circuit breaker on welder. (Check for loose mechanical.)
- Tripped or bad circuit breaker at house panel. (Check for loose mechanical & and confirm continuity.)
- Loose power cable inside wall plug. (Clean & Tighten Clamping.)
- Loose power cable at gun (or ground plate). (Clean & Tighten Clamping.)
- Loose harness inside cabinet. (Inspect, smell and feel for looseness or burn.)
- Bad circuit board or thyristor module. (Confirm 208v at thyristor. Send in for repair.)